Magazine VICLA

How to calculate press brake tonnage: formula and example | VICLA

Written by VICLA | Nov 20, 2026, 11:00:01 PM

Tonnage is the force a press brake needs to bend a part. Get it right and you choose the correct machine, the correct die and a safe setup. Here is the formula, a worked example and the factors that move the number.

The air-bending formula

For air bending, the bending force per metre of bend is approximately:

F (kN/m) ≈ (1.33 × Rm × s²) / V

where Rm is the material tensile strength in N/mm², s is the thickness in mm, and V is the die opening in mm. As a rule of thumb the die opening is about eight times the thickness.

A worked example


Take 3 mm mild steel (Rm about 450 N/mm²) with a die opening V of 24 mm (eight times the thickness):

  • F = (1.33 × 450 × 3²) / 24 = (1.33 × 450 × 9) / 24 ≈ 224 kN/m

That is about 22.9 tons per metre, so a 2 metre bend needs roughly 46 tons. A quick cross-check with the rule of thumb (7 to 8 tons per metre per millimetre) gives about 22 to 24 tons per metre, which matches.

What changes the tonnage

  • Thickness: force rises with the square of thickness, so it climbs fast.
  • Material strength: stainless and high-strength steel need more force than mild steel.
  • Bend length: force is spread along the bend, so longer bends need more total tonnage.
  • Die opening: a wider V lowers the force but increases the inside radius.
  • Bending method: bottoming and coining need far more force than air bending.

Use a calculator

The formula gives a solid estimate, but the real number depends on your exact material, die and method. The VICLA bend parameter calculator does the maths for you, and a tonnage chart confirms it before you cut.

Frequently asked questions

Why does thickness matter so much?

Force rises with the square of thickness, so doubling thickness roughly quadruples the force.

Does a bigger die reduce tonnage?

Yes, a wider V lowers the force, but it also increases the bend radius.

Is air bending the lightest on force?

Yes, bottoming and coining need much more tonnage.